Guntermann & Drunck FIBREVision - Handbuch (Seite 86)

Initiation
G&D FIBREVision · 13
English
Initiation
After the FIBREVision system has been properly installed, it can be immediately put
into operation.
Mind the following activation sequence while initiating the system:
1. Use the switch above the Power socket to turn on the user module
(FIBREVision-CON).
2. Use the switch above the Power socket to turn on the computer module
(FIBREVision-CPU).
3. Turn on the computer, which is connected to the computer module.
After the FIBREVision system has been switched on, the LEDs on the front panel of
both the computer module and the user module signal the system’s operating status.
For further advices on this topic, also see the chapter Status displays on page 50 ff.
NOTE: The recommended activation sequence ensures that the FIBREVision sys-
tem is able to read out the features of the connected monitor and to transmit them
to the computer.