Sony SIR-3400H - Handbuch (Seite 107)

(E)
15-11 SIR-3400H / SIR-3032i / SIR-3032W
15. Data Recording/Playback
15-6. Trigger Recording
15-6-1. Connecting the Trigger Signal
1
Set the trigger mode Single or Multi according to the purpose. (See section 8-1.)
- In REC-PAUSE mode -
<When set to Single>
Recording starts when the trigger input signal changes from High to Low, and it continues recording
until the STOP key is pressed.
<When set to Multi>
Recording starts when the trigger input signal changes from High to Low, and the mode changes to
REC-PAUSE when the signal changes from Low to High.
2
Use a BNC cable (sold separately) to connect the TRIG REC IN connector on the rear panel and the
trigger signal.
c
. It the ADDRESS duration is less than 2 seconds, the next signal may not start up.
. The input voltage level should be TTL level.
Signal source