Sony SIR-3400H - Handbuch (Seite 108)

15-12
(E) SIR-3400H / SIR-3032i / SIR-3032W
15. Data Recording/Playback
15-6-2. Trigger Recording
1
Set the recording unit to REC-PAUSE mode.
2
Input the trigger signal from the trigger signal source, or press the PAUSE key to cancel REC-PAUSE
mode.
Recording is started.
<When pre-trigger recording is set to On>
Recording is performed according to the preset pre-trigger time based on the recording speed.
c
Before the trigger signal is input, if REC-PAUSE mode is not held for the pre-trigger time, the entire
pre-trigger data cannot be recorded. If the recording speed is set to 1/2, 1/4, and so on, the pre-trigger
time becomes 2
x, 4x, and so on respectively by comparison of 1x (approx. 2 seconds) pre-trigger time.
<When pre-trigger recording is set to Off>
Data is recorded immediately after being triggered.
* See section 8 for pre-trigger recording.
15-6-3. Playback of the Pre-trigger Data
The pre-trigger data is played back with the ADDRESS “-000H00M00S”.