Burkert Type 1110 - Handbuch (Seite 44)

42 - 1110
DIGITAL INDUSTRIAL CONTROLLER
english
Numeric values have to be set when setting a setpoint in the process operation
level, but also when defining parameters and when configuring. This can be done by
means of the „Up arrow“ and „Down arrow“ keys. Figure 25 shows the principle of
setting numeric values with reference to a controller’s reset time T
r
.
Pressing the “Arrow down” key will switch one position to the left each time, starting
with the lowest position (Position selection). The position will blink to indicate that it
is selected. By pressing the ,Up arrow“ key, the value in the flashing position can be
altered from 0 to 9 (highest position from -1 to 9). The value set is saved by pressing
the ENTER key. If the SELECT key is pressed after entering a numeric value, the
value is cancelled and the original numeric again appears in the display.
You can move the decimal point by one position to the left by pressing the ,Up
arrow“ and ,Down arrow“ keys at the same time. Not all numeric values allow you to
move the decimal point, however.
The parameters can now be set within the pre-defined setting ranges (cf., Par.
6.5.4). If a value is entered which is outside the permitted range, it will be set to the
limit value that would have been exceeded when confirmed by the ENTER key.
6.4 Setting numeric values
Figure 25: Setting the number values.
➨
0.....9
ENTER
SELECT
➤ ➤
DISPLAY
1110 C o n t
T r
r o l 1
0
.
.
.
9
-1
0
.
.
.
9
0.....9
0.....9 ➨
1110
0.....9
0.....9 ➨
1110
modifying
numeric value
digit selection
moving
position of
decimal
point