Burkert Type 1110 - Handbuch (Seite 48)

46 - 1110
DIGITAL INDUSTRIAL CONTROLLER
english
6.5.3 Configuration menus
Figures 28 to 32 show the configuration menus for the 5 possible control structures
in the form of flow charts. These flow charts contain selection blocks and
specification blocks.
Selection blocks:
Here, you can make a selection from a number of possibilities (options). The
individual possibilities are each listed adjacently in a selection block (vertical
lettering). Select an option by pressing the SELECT key. In the selection blocks, this
is indicated by a horizontal arrow. You can confirm an option and switch to the next
block by pressing the ENTER key. This is indicated by vertical arrows next to the
connecting lines between the blocks.
Specification blocks:
Here, numeric values must be defined for parameters. The individual parameters in
a specification block are listed one below the other. The numeric values are set with
the „Up arrow“ and „Down arrow“ keys (see Section 6.4). You can confirm set
numeric values and switch to the next parameter by pressing the ENTER key. In the
specification blocks, this is represented by a vertical arrow (see Figure 27). Before
confirming and switching further by pressing the ENTER key, you can cancel a set
value by pressing the SELECT key (cf. Section 6.4).
Key to press Displayed arrow
ENTER
SELECT
↓
→
Figure 27: Meanings of the arrow in the configuration menu
The informations and symbols contained in the following configuration menus are
explained in section 6.5.4.