Gb 4. design and function – WIKA CTM9100-150 Benutzerhandbuch
Seite 13

13
WIKA operating instructions, models CTD9100, CTB9100, CTM9100
11263911.02 05/2014 GB/D
GB
4. Design and function
4.4 Isometric views of the CTD9100 series dry-well temperature calibrators
Front and top of the model CTD9100
On the top of the dry-well temperature calibrator, you will find
the dry well access opening for inserting the inserts.
■
CTD9100-COOL: Ø 28 mm x 150 mm
■
CTD9100-165:
Ø 28 mm x 150 mm
■
CTD9100-165-X: Ø 60 mm x 150 mm
■
CTD9100-450:
Ø 60 mm x 150 mm
■
CTD9100-650:
Ø 28 mm x 150 mm
The controller, with display and controls, is located on the
front of the calibrator.
Rear of the instrument
On the rear of the equipment is the product label with the key
information about the particular model.
■
CTD9100-COOL: -55 ... +200 °C
■
CTD9100-165:
-35 ... +165 °C
■
CTD9100-450:
40 ... 450 °C
■
CTD9100-650:
40 ... 650 °C
The correct mains voltage and frequency is also given.
■
AC 100 ... 240 V, 50 ... 60 Hz
■
AC 115 V, 50 ... 60 Hz
■
AC 230 V, 50 ... 60 Hz
Furthermore, the individual serial number (e.g. S/N 550 33 44)
as well as the mains voltage and the fuse rating is given.
You will also find the connector for the RS-485 interface here.
Underside of the instrument
On the underside of the instrument are the mains connection
socket and the power switch with its fuse-holder.
These are located in the centre, at the front. Furthermore,
depending on the model, there are one or two air intakes
located on the underside of the instrument.
The air intakes must not be obstructed in any way.
Mains
connection
socket with
power switch
Fan 1
Fan 2
Block
RS-485
interface
Product
label
Block
Controller
Handle