Guntermann & Drunck DL-Vision(M/S) - Handbuch (Seite 85)

Using the Reset button
G&D DL-Vision(M/S) · 19
English
Using the Reset button
The Reset button is placed between the Identification LED and the RS 485 interface on
the front panel of the computer module and the user module.
The button enables you to reset the default settings and to temporarily deactivate the
netfilter rules.
Resetting the default settings
Pressing and holding the button during booting resets the defaults of the KVM
extender.
How to reset the default settings:
1. Switch off the device if in operation.
2. Press and hold the Reset button on the front panel of the device.
3. Keep the button pressed and switch the device on.
4. Release the button as soon as the green System LED is blinking.
NOTE: As protection against pressing the button accidentally, it is located behind a
drilling in the front panel.
Use a thin, pointed item to press the button.
NOTE: After this function has been carried out, the default settings of the KVM
extender listed on page 21 are reactivated.
NOTE: You can also reset the default settings in the Config Panel web application
(see page 41).
When resetting the defaults via web application, the configuration of the network
interfaces can be maintained.