WIKA CTD9300 - Handbuch (Seite 14)

9037926 03/2005
14 WIKA Operating Instructions CTD 9300 Rev. 1
Temperature Dry Well Calibrators CTD 9300
2. Device Description
GB
2.4 Standard Accessories
Power Cable
A power cable with a 90 ° angled inlet connector for the power
supply is included with every calibrator. Depending on the country
the calibrator is delivered to, the power cable is fitted with the
locally used power plug.
Adapting Sleeve
Each calibrator is delivered ex works with an adapting sleeve with
an inside diameter of 6.5 mm. Most of the industrial thermometers
can be adapted to the calibrator through this sleeve.
If the diameters of your thermometers differ, please order the
desired adapting sleeve with an internal bore matching the diameter
of your thermometer plus 0.5 mm.
Sleeve Removal Tool
A sleeve removal tool for simple and easy removal from and
insertion of the adapting sleeve into the calibrator block is included
in the standard set of accessories of every temperature calibrator of
the CTD 9300 series.
Data Cable
A data cable for connecting the calibrator to the RS 232 interface is
included in the scope of delivery of each device. The PIN layout
plan for 9-pin and 25-pin Sub-D connectors can be found in the
Appendix, refer to section 6.6: PC Connection.
2.5 Special Accessories
The special accessories are not included in the standard scope of
delivery.
Standard deviations as well as the min. and max. values can be
reset at any time by pressing the ENTER
(E) key.