WIKA CTD9300 - Handbuch (Seite 65)

9037926 03/2005
65 WIKA Operating Instructions CTD 9300 Rev. 1
GB
Temperature Dry Well Calibrators CTD 9300
6. Appendix
6.5 Type Label
The type label holds the following information:
It is attached to the rear of the calibrator.
Fig. 38: Type label of a CTD 9300
6.6 PC Connection
The calibrator is equipped with a serial interface of the RS 232 C
type. This interface operates in two directions, i.e. data are sent
to a superordinate computer for further processing and data are
received from a superordinate computer for programming the
device.
RS 232 Settings
Baud Rate and Parity
2400 Baud, 4800 Baud and 9600 Baud are supported. They are
selected with the cursor keys and enabled with the SELECT key.
The following default settings have been made ex works:
9600 Baud, 8 data bits, parity none, 1 stop bit
If your CTD 9300 cannot be switched on, you might have to
check and replace the fuse.