HEIDENHAIN ND 780 - Handbuch (Seite 131)

ND 780
7
Readout P
a
ramet
e
r P
ass Code
Readout Parameter Pass Code
An pass code must be entered before machine-related installation
parameters can be set or changed. This prevents inadvertent
adjustments to the installation setup parameters.
Access to Machine Parameter Operations
Refer to the Installation Setup section also See "Installation Setup
Parameters" on page 87.
Begin by pressing the SETUP soft key.
Press the soft key INSTALLATION SETUP.
Press the pass code numbers 95148 using the numeric key pad.
Press the ENTER key
The readout is now ready for machine parameter setting operations
IMPORTANT!
The pass code is 95148.
IMPORTANT!
Supervisors may wish to remove this page from the
Reference Manual after initially setting up the readout
system. Retain in a safe place for future use.