Metrohm tiamo 1.2 Manual - Handbuch (Seite 136)

110 Workplace
• Sample data
Entry of method and sample identification for the next determination.
• Properties
Definition of the properties for the tab Single determination .
Operating tools
The tab Single determination contains the following operating tools:
Start single determination (short cut: Ctrl G)
This button is present in the status READY (no determination has been
started), COND READY (conditioning criterion has been fulfilled) and COND
BUSY (conditioning is running). When a start can be triggered it is green,
otherwise light gray. For methods with conditioning the conditioning is
started first.
Stop single determination (short cut: Ctrl S)
The button is present in the status
BUSY (determination is running), COND
READY (conditioning criterion has been fulfilled) and COND BUSY (condition-
ing is running), i.e. when conditioning has been started.
Interrupt Run
This button is active (dark gray) in the status BUSY (determination is run-
ning), COND READY (conditioning criterion has been fulfilled) and COND BUSY
(conditioning is running). In all other cases the button is inactive (light gray).
After pressing
[Hold] the [Cont] button appears in its place.
Continue Run
This button is only present in the status
HOLD (determination interrupted)
and COND HOLD (conditioning interrupted). After pressing [Cont] the [Hold]
button appears again.
Status display
On the tab Single determination the current status of the workplace is shown:
Status
READY
Ready for the start of a determination or for conditioning.
BUSY
Determination is running.
HOLD
Determination is interrupted.
COND BUSY
Conditioning is running.