Metrohm tiamo 1.2 Manual - Handbuch (Seite 730)

704 Configuration
Oven
On the tab Oven the oven parameters for the 774 Oven Sample Processor are
shown. The parameters cannot be edited, they are only read off by the device.
Initial temperature
Shows the initial temperature set on the device. Entering an initial tempera-
ture means that the oven will heat up to the set temperature when it is
switched on. off means that the oven will not be switched on.
Max. temperature
Shows the maximum temperature set on the device. This parameter is a
safety setting and is intended to prevent a sample from being overheated. If
the oven reaches this temperature on heating up then the oven heating will
be switched off.
Temperature correction
Shows the temperature correction set on the device. This parameter directly
affects the temperature control and allows it to be adjusted. In this way any
temperature difference that may occur between the oven and sample can
be compensated. The displayed temperature is the oven temperature cor-
rected by this value.
Gas
On the tab Gas the parameters for the gas flow to the 774 Oven Sample Proces-
sor are shown. These parameters cannot be edited; they are only read off by the
device.