Metrohm tiamo 1.2 Manual - Handbuch (Seite 48)

22 General program functions
Identifier Description Commands
.BLV Blank value of the sensor used for the command (for ISE sen-
sors only) or the blank value calculated during calibration (for
CAL LOOP Conc)
DET U, MET U,
SET U, STAT U,
MEAS U, MEAS
Conc, CAL LOOP
Conc, DOS U
.BP{#}.DME Difference in measured values for break point # (1...9) MET
.BP{#}.ERC ERC or 1st derivative for break point # (1...9) DET
.BP{#}.MEA Measured value for break point # (1...9) in the units of the
measured value DET, MET, MEAS
(without T/Flow)
.BP{#}.TEM Temperature for break point # (1...9) in °C DET, MET, MEAS
(without T/Flow)
.BP{#}.TIM Time for break point # (1...9) in s DET, MET, MEAS
(without T/Flow)
.BP{#}.VOL Volume at break point # (1...9) in mL DET, MET
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not present) = Command has never
been started All except START
and END
.CBY Command status; 1 = conditioning active, 0 = condition-
ing not active SET, KFT, KFC
.COK Command status; 1 = conditioning criterion fulfilled, 0 =
conditioning criterion not fulfilled
SET, KFT, KFC
.CONC Concentration of the solution used for the command DET, MET, SET,
KFT, STAT, ADD,
DOS, LQH,
STDADD
.CYL Cylinder volume of the exchange or dosing unit used for the
command DET, MET, SET,
KFT, STAT,
STDADD dos,
STDADD auto,
ADD, DOS, LQH,
PREP, EMPTY
.DBL Total duration for processing the command in s DET, MET, SET,
KFT, KFC, STAT,
MEAS, CAL MEAS,
STDADD, DOS
.DRI Current or last drift for drift correction in µL/min SET, KFT, KFC
.DSC Duration for processing all start conditions in s DET, MET, SET,
KFT, STAT
.DTI Time for the drift correction (time from start of titration until end
of command) in s
SET, KFT, KFC
.EGF Last measured gas flow (measured value after processing the
command) in mL/min MEAS T/FLow
.EME Final measured value (measured value after processing the
command) in the units of the measured value DET, MET, SET,
KFT, KFC, STAT,
MEAS, CAL MEAS,
STDADD, DOS