Metrohm tiamo 1.2 Manual - Handbuch (Seite 654)

628 Configuration
Templates for input lines
With the menu item Tools, Templates, Input lines the dialog window Templates for
input lines opens in which the client-specific bit-pattern for scanning remote input
signals can be defined, these can be selected with the command SCAN and in
Manual Control.
Template table
The table with the defined templates cannot be edited, however, with a mouse
click on the column title it can be sorted according to the selected column in ei-
ther an increasing or decreasing sequence.
Generates a new template (see below).
Edits the selected template (see below).
Deletes the selected template.
Generate new template or edit template
With [New] or [Edit] the dialog window New template or Edit template opens for en-
tering a new template or for editing an existing template respectively.
Signal name
25 characters
Name of the template for the input signal.
Input signal
Bit-pattern with 8 characters (0, 1, *), [ ******** ]
Entry of the bit-pattern for the input signal with exactly 8 characters.
The following characters can be entered
0 = line inactive,
1 = line active, and
* = any line condition.
The input lines and bits are numbered from right to left:
Input 7 6 5 4 3 2 1 0
Bit 7 6 5 4 3 2 1 0
Example: *******1 expects an active input line 0 ( 1 = set). This line will be
set, e.g. by a Titrino when a titration has been finished and the Titrino can
again receive a start signal.