Metrohm tiamo 1.2 Manual - Handbuch (Seite 547)

Commands 521
Dosing rate
[ maximum ]
0.01 ... 166.00 mL/min
(Titrando)
0.01 ... 150.00 mL/min (Titrino)
Speed at which dosing is carried out. The maximum dosing rate depends
on the cylinder volume of the exchange unit or dosing unit used. In case the
entered dosing rate is too high for the selected dosing device, the rate will
be reduced automatically to the highest possible value. This parameters is
only displayed for Dosing criterion = Volume/Dosing rate or Volume/Dosing
time.
Note
Lower dosing rates should be entered for solutions with higher viscosities.
Dosing time
0 ... [ 100 ] ... 9999999 s
Time during which dosing is to be carried out. This parameter is only dis-
played for Dosing criterion = Volume/Dosing time or Dosing rate/Dosing time..
Pause
[ 0 ] ... 999999 s
Waiting period before dosing is started.
Temperature
-20.0 ... [ 25.0 ] ... 150 °C (Titrando)
-170.0 ... [ 25.0 ] ... 500 °C (Titrino)
Manually entered measuring temperature. If a temperature sensor is con-
nected and
temperature measurement on the tab General/Hardware is set to
automatic or continuous , the temperature is measured continuously. The
value is used for the temperature adjustment during the measurement.
Time interval measuring point
0.1 ... [ 5.0 ] ... 999'999 s (Titrando)
1 ... [ 5 ] ... 999'999 s (Titrino)
Time interval for entering a measuring point in the list of measuring points.
Stop conditions
Conditions for stopping the dosing. The stop conditions are checked at the same
time and the condition which is fulfilled first stops the titration.
Command name
25 characters, [ DOS pH # ]
Name of the command.
Stop volume
0.00000 ... [ 100.000 ] ... 9999.99 mL, off (Titrando)
0.000 ... [ 100.000 ] ... 9999.99 mL, off (Titrino)
Stops when the given volume has been added after the start of the dosing.
The stop volume should be adapted to suit the sample weight or the titra-
tion vessel size.