Metrohm tiamo 1.2 Manual - Handbuch (Seite 440)

414 Method
• Control parameters
Control parameter for the endpoint (measured value for the endpoint, titra-
tion rate, user defined parameters, stop criterion).
• Titration parameters
Parameters for the run of the titration.
• Stop conditions
Definitions of conditions which cause the stop of the titration.
• Conditioning
Switching conditioning on/off. Definition of start drift, drift correction and
stop condition.
• Additional evaluations
Definition of additional methods for evaluation of the titrations curves.
•
Additional measured values
Definition of additional measured values of other measuring commands
which are saved as additional column in the list of measuring points.
General/Hardware
Screenshot and parameters: see DET Upol - General/Hardware
Start conditions
Screenshot and parameters: see SET Upol - Start conditions
Control parameters
Screenshot and parameters: see SET Upol - Control parameters
Titration parameters
Screenshot and parameters: see KFT Ipol - Titration parameters
Stop conditions
Screenshot ans parameters: see SET pH - Stop conditions
Conditioning
Screenshot and parameters: see SET pH - Conditioning
Additional evaluations
Screenshot and parameters: see SET Upol - Additional evaluations
Additional measured values
Screenshot and parameters: see DET pH - Additional measured values