Metrohm tiamo 1.2 Manual - Handbuch (Seite 596)

570 Method
SEND - event messages
Receiver
[ System ], Command
Selection of the type of receiver.
Selection
Command name, [ 'empty' ]
Selection of the command which a message should be sent to. All the
commands defined in the method are available for
Receiver = Command .
For Receiver = System this parameter is not editable.
Event message
[ Quit ], Hold, Stop (for Receiver = System )
[ Quit ], Hold, Continue, Start Titration (for Receiver = Command )
Selection of the event message to be sent. The following event messages
can be selected depending on the type of receiver:
Receiver Selection Event message Meaning
System - Hold
Hold determination (all tracks). Corresponds
to the button [Hold] in the dialog window Run.
System - Quit Cancel determination (Series continues).
System - Stop
Cancel determination and series. Corresponds
to the button
[Stop] in the dialog window Run.
Command
All track com-
mands
Hold Hold selected track.
Command
All track com-
mands
Continue Continue selected track.
Command
All track com-
mands
Quit
Cancel selected track.
If the selected track contains a command
being conditioning, conditioning is only
stopped if the option
Automatic conditioning is
disabled in the command START .
Command All commands Hold
Hold selected command. Also valid for condi-
tioning.
Command All commands Continue
Continue selected command. Also valid for
conditioning.
Command All commands Quit
Cancel selected command.
If the selected command is being condition-
ing, conditioning is only stopped if the option
Automatic conditioning is disabled in the com-
mand START .
Command SET, KFT, KFC Start Titration
Start titration. For this, the option Only start
titration by a start command from a SEND com-
mand
must be enabled on the tab Conditioning
of the titration command (Example: KFT).