Metrohm tiamo 1.2 Manual - Handbuch (Seite 219)

Report templates 193
Curve field - x axis
X pos.
0.0000 ... (max. page width) mm
x-position within the permitted section.
Y pos.
0.0000 ... (max. page height) mm
y-position within the permitted section.
Width
0.0000 ... (max. page width) mm
Width of curve field.
Height
0.0000 ... (max. page height) mm
Height of curve field.
Command type
[ DET ], MET, SET, KFT, KFC, MEAS, MEAS T/Flow
Selection of the type of command for which a curve is to be shown.
Command name
[ not defined ], 50 characters
Name of the command for which a curve is to be shown. With not defined all
curves present in the determination with the selected Command type will be
produced as default.
Note
In the command name, the index in the format
.# must be specified additionally
(e.g. Chloride.1 ).
Autoscaling
[ on ], off
If this option is enabled then all the axes in the curve window will be scaled
automatically. In this case the fields Start value and End value cannot be ed-
ited.
Parameters for the graphical display of the curve on the x axis.
Quantity
Command-dependent selection
Selection of the quantity to be shown on the x axis.
Label
50 characters, [ auto ]
Freely definable axis labeling for the x axis. With auto the name from the
Quantity will be used.