Metrohm tiamo 1.2 Manual - Handbuch (Seite 52)

26 General program functions
Identifier Description Commands
.RE{x}.DRC Correlation coefficient for mean dosing rate in window x (1...9) STAT
.RE{x}.DRS Standard deviation for mean dosing rate in window x (1...9) in
mL/min STAT
.RE{x}.DRT Mean dosing rate in window x (1...9) in mL/min STAT
.RE{x}.RWL Lower limit of evaluation window x (1...9) in s STAT
.RE{x}.RWH Upper limit of evaluation window x (1...9) in s STAT
.RES Calculated result for standard addition in selected unit STDADD
.RPO Current rack position (entry at end of command); 0 means 'not
defined' MOVE
.SAN Current absolute swing angle of the swing head in ° (entry at
end of command) MOVE, SWING
.SLO Electrode slope of the sensor used for the command (in % for
pH sensor or mV for ISE sensor) or the electrode slope calcu-
lated from the calibration (for STDADD and CAL LOOP)
DET pH, DET U,
MET pH, MET U,
SET pH, SET U,
STAT, MEAS pH,
MEAS U, MEAS T,
MEAS Conc,
STDADD, CAL
LOOP, DOS
.SME Starting measured value (measured value after processing the
start conditions) in the units of the measured value
DET, MET, SET,
KFT, KFC, STAT
.SPO Current external position (entry at end of command); 0 means
invalid position SWING
.STE Start temperature (temperature after processing the start con-
ditions) in °C DET, MET, SET,
KFT, KFC, STAT
.STY Stop type with which the command has been stopped: 1 =
normal;0 = manual or after error DET, MET, SET,
KFT, STAT, MEAS,
CAL MEAS,
STDADD, DOS
.SVA Start volume absolute (volume added in accordance with the
start condition "Start volume") in mL
DET, MET, SET,
KFT, STAT
.SVM Start volume measured value (volume added in accordance
with the start condition "Start measured value") in mL DET, MET
.SVS Start volume measured value (volume added in accordance
with the start condition "Start slope") in mL DET, MET
.SVT Start volume total (volume added in accordance with all three
start conditions) in mL DET, MET, SET,
KFT, STAT
.TITER Titer value for the solution used for the command DET, MET, SET,
KFT, STAT,
STDADD dos,
STDADD auto,
ADD, DOS, LQH
.TOU Timeout status: 1 = max. delay period elapsed; 0 = max.
delay period not elapsed RECEIVE, TRANS-
FER; SCAN
.VAR Variance of the calculated standard addition result in selected
unit STDADD
.VOL Added volume STDADD, ADD,
DOS, LQH