Meas upol – Metrohm tiamo 1.2 Manual Benutzerhandbuch
Seite 497
Commands
471
MEAS Upol
Command for amperometric measurements with selectable polarization volt-
age.
Devices
This command can be executed with the following devices:
Titrino: 702, 716, 718, 719, 720, 721, 736, 751, 758, 785, 794, 798, 799
Titrando: 808, 809, 835, 836, 841, 855, 857
Appearance
The command has the following appearance:
Parameters
The parameters for the command
MEAS Upol
are configured on the following 4
tabs:
•
General/Hardware
Parameters for device, sensor and stirrer.
•
Measuring parameters
Parameters for the measurement.
•
Evaluations
Defining further methods for evaluating measurement curves.
•
Additional measured values
Defining further measured values which can be saved as additional col-
umns in the list of measuring points.