Metrohm tiamo 1.2 Manual - Handbuch (Seite 799)

Determinations 773
7.3 Determinations
7.3.1 Start single determination
Single determination without statistics
1.
Select program part Workplace.
2. In subwindow Run , click on tab Single determination .
3. If desired, enter Determination parameters.
4. Select Method from the desired method group that is to be used for carrying out
the determination.
The subwindow
Method shows the method loaded.
5. If a method was loaded in which the option Statistics in the START command is
enabled, disable the checkbox Statistics on the tab Single determination .
6. Enter Sample data.
7. Click on [Start] .
The single determination will be started. The subwindow Method shows active
tracks and commands, the subwindow Live display live curves, measured values
and messages.
Single determination with statistics
1.
Select program part Workplace.
2. In subwindow Run , click on tab Single determination .
3. If desired, enter Determination parameters.
4. Select Method from the desired method group that is to be used for carrying out
the determination.
The subwindow
Method shows the method loaded.
Note
In order to calculate statistical calculations for results, the option Statistics must
be enabled in the START command of the method and, additionally, the option
Statistics must be enabled in the CALC command of each desired result.
5. Enable the checkbox Statistics on the tab Single determination and modify the
number of single determinations if desired.
6. Enter Sample data.
7. Click on [Start] .
The single determination will be started. The subwindow Method shows active
tracks and commands, the subwindow Live display live curves, measured values
and messages.
Note
If the method contains a DATABASE command, this command must be executed
in all statistically linked determinations. Otherwise the statistical results will be
displayed faulty and the determinations cannot be reprocessed.