Metrohm tiamo 1.2 Manual - Handbuch (Seite 294)

268 Database
4.11 Subwindow Curves
4.11.1 General
Subwindow Curves
The subwindows Curves 1...5 are subwindows in the program part Database, in
which the measuring points generated by the measure commands for the focused
determination in the Determination table are shown as a graph. When navigating
in the determination overview this data will be updated automatically (with a cer-
tain delay).
The subwindows Curves 1...5 can be switched on in the program part Workplace
during the definition of the Layout and thus made visible. They can be enlarged
and diminished as required; they can also be maximized.
Tabs
In the curve window a tab with the corresponding command name and the run in-
dex (e.g.
Chloride.1 ) is provided for each execution of a measure command; their
sequence is determined by the method.
Show curves
The curves of the selected determination are shown on the tabs with the Proper-
ties defined per window and per command type. The command type (e.g.
DET pH )
is shown above the left-hand y axis.
Curves can be zoomed as often as required by spanning a section of the curve
display with the left-hand mouse key pressed down. Zooming can be undone with
a double-click on the section of the graph or with the context-sensitive menu
command
Show all .
Note
When a new determination is selected the complete curve is always shown, i.e.
the zoom range is not retained when the determination is changed.
Curves can be copied into the clipboard with the context-sensitive menu com-
mand
Copy graphics .
Show measuring point list
With the context-sensitive menu item Measuring point list... in the curve window the
dialog window Measuring point list - 'Command name' opens for showing the meas-
uring point list for the selected curve.
Show monitoring report
If the method contains commands of type STAT or DOS , with the context-sensitive
menu item Monitoring report... in the curve window the dialog window Monitoring
report - 'Command name' opens for showing the monitoring report.